Black Widow Security BW RAS 100 Manuale di Installazione Scaricare il pdf (Pagina 7)

- 6 -

TROUBLESHOOTING

PROBABLE SUGGESTED

SYMPTOM CAUSE CORRECTION

Unit is triggered any BLUE wire is shorted to ground Disconnect the wire to see if

time it is armed. or the BWS-296 or optional sensor the symptom stops. If so, check

is not correctly adjusted. the wire for shorts or readjust

sensor fittings.

Alarm will not rearm WHITE wire is connected to pos- Check WHITE and BLU/WHT

or will not passively itive voltage, BLU/WHT wire is wires with doors closed and

arm. connected to ground, GREEN wire open, and GREEN wire with ig-

is connected to permanent posi- nition switch off and on, for

tive voltage, or pinswitch is bad. correct voltage changes. Repair

and/or rewire as needed.

Alarm will arm from Dipswitch #4 is off.VIOLET Set dipswitch #4 to ON. Check

transmitter but will wire is shorted to ground. VIOLET wire for shorts.

not passively arm.

Remote Control does Defective Remote Control. Bad Replace Remote Control or its

not arm or disarm battery. Antenna wire is battery. Un-ground antenna.

alarm. grounded.

Valet does not work. Wire from Valet switch to ground Test for switched ground at alarm

is not connected to a good ground unit. Repair or replace as needed.

or wire from switch to unit is

open. Bad switch.

Flashing output does Bad connection on WHT/ORG Check WHT/ORG wire. Connect

not work. wire or the drive polarity is a SPDT Relay to this wire and

wrong for the circuit being apply the opposite polarity to the

driven. circuit being driven.

Door locks do not Defective GRN/BLK or YELLOW Check GRN/BLK and YELLOW

lock/unlock correctly, wiring. GRN/BLK and YELLOW wires. Check vehicle’s door lock

or action is reversed. wires reversed, or wrong door system for method of operation.

lock wiring used. Reverse wiring to door relays.

1 2 3 4 5 6 7 8

Nessun commento

Black Widow Security BW RAS 100 Manuale di Installazione Pagina 7